Thanks for helping Ukraine! Victory will be ours!

The switch is intended for switching on-board devices powered directly from the power battery: electric motors, speed controllers, lamps, etc. The recommended supply voltage range is 2-3 LiPo cells. To bring the switch to the “ON” position, press and hold the button for 0.5 seconds. The “ON” state is indicated by a lit green LED. To bring the switch to the “OFF” state, press and hold the button for 0.1 seconds.

1. Switching voltage: 6...15 V
2. Continuous working current: 40A
3. Short-term operating current: 200A
4. Through resistance: 0.0009 Ohm
5. Temperature range: -10...+40 оС
6. Connector standard: DEANS ULTRA (T-shaped)
7. Dimensions (without wires): 28 x 21 x 8mm
8. Weight (with wires): 22g
9. Resource (number of on-off): 50000

The switch has a “memory” effect, that is, if the power battery is disconnected from the switch connector and then connected back, the switch will “remember” the initial state.

WARNING!
The design of the circuit breaker is not hermetic; during installation, it should be protected from dust and drops of water or fuel; it is also desirable to provide protection against vibration. It is recommended to install the switch in a place where it is provided with air flow.

Continuous use of this device for more than 1 hour is not recommended. When storing the model, the switch (as well as other consumers) must be disconnected from the running battery in order to avoid its discharge and failure. Lithium-polymer batteries are a source of increased danger and require constant monitoring of modes and voltage levels during charging and discharging.
 


Main
Type system Brushless, Collector
Weight (g) 22
Dimensions (LхWхH) (mm) 28 х 21 х 8
Supply voltage (V) 6-15
Current (A) 40

Write a review

Please login or register to review

Power board switch SWPS-40 (40А)

  • $12.15


Order in 1 click

We will call you back and clarify the details

Related Products

Power board switch SWPS-70 (70A+)

Power board switch SWPS-70 (70A+)

The power switch is intended for switching on-board devices,  eating  directly from the po..

$16.50

Tags: Switch, Electronic, Remote

Featured

What you need to know about the propeller

What you need to know about the propeller

How does a propeller work? A propeller converts rotation engine shaft at point blank range - the force pushing the ship forward. When the propeller ro..

Rules for charging and using LiPo batteries

Rules for charging and using LiPo batteries

A few REQUIRED rules for charging and using LiPo batteries: 1. Use only a charger designed for lithium batteries. The charger can be designed to ch..