Two-channel multiswitch MSWTFP-2HPV is designed for discrete separate switching on and off of two external loads: LEDs, lamps, relays and solenoids. Only one of the two loads (channel 1 or channel 2) can be in the off state and only for 1 second after switching on. The main target load of this multiswitch is the electromagnetic latches (solenoids) of the bait boat bunkers. This type of load is characterized by low winding resistance and does not allow continuous (long-term) switching on.

The multiswitch is controlled via a free channel of the control panel, the device itself is connected to the corresponding channel of the receiver. It is recommended to use a control panel channel with a three-position toggle switch. It is allowed to use a proportional control channel with the possibility of fixing the handle of the control panel in the neutral position.

The multiswitch circuit is powered from the receiver's power bus. The loads connected to the multiswitch outputs are powered by an external source (battery or UBEC) connected via an external power cable (see Fig. 2).

A feature of this multiswitch is the use of field-effect transistors with a P-channel as power elements for switching the plus of the power source and providing a common minus (ground) for the battery, receiver and other on-board consumers.

Load on-off point settings are fixed (see Fig. 1). In neutral position N, load outputs 1 and 2 are switched off. When the handle of the control panel (toggle switch) is moved to sector B, the load output 1 and LED1 are turned on. Then the load of channel 1 will turn off after 1 second, regardless of the further position of the knob. To turn the channel 1 output back on, move the knob to neutral position N and then return it to sector B. In this case, the channel 2 load is off. The channel 2 load is controlled in the same way, by moving the knob to sector A and returning it to the neutral position N. When the channel 2 load is turned on, LED2 lights up. Channel 1 and LED1 are switched off. In some cases it may be necessary to adjust the N, A and B setpoints using the remote

TECHNICAL SPECIFICATIONS
Dimensions (without wires): 40x17x7mm
Weight (with wires): 11 g
Number of channels (outputs): 2
Channel operating current: 10A
Power supply voltage: 3 ~ 30V
Power Connector Standard: JST