Two-channel multiswitch MSWFP-2HPV is designed for discrete separate switching on/off of two external loads: LEDs, lamps, relays, solenoids, low-power electric motors, etc. The outputs of the load channels can be turned on or off arbitrarily independently of each other.

Multiswitch MSWFP-2HPV can turn loads on and off with current consumption up to 10 A and supply voltage up to 30 V.

The multiswitch is controlled via a free channel of the control panel, the device itself is connected to the corresponding channel of the receiver. It is recommended to use a control panel channel with a three-position toggle switch. It is allowed to use a proportional control channel with the possibility of fixing the handle of the control panel in the neutral position.

The multiswitch circuit is powered from the receiver's power bus. The loads connected to the multiswitch outputs are powered by an external source (battery or UBEC) connected via an external power cable (see Fig. 2).

A feature of this multiswitch is the use of field-effect transistors with a P-channel as power elements for switching the plus of the power source and providing a common minus (ground) for the battery, receiver and other on-board consumers.

Load on-off point settings are fixed (see Fig. 1). In the neutral position N, the current state of the channels is fixed. When the handle of the control panel (toggle switch) is moved to sector B, the load of channel 1 and LED1 is turned on. When the joystick returns to the neutral N position, channel 1 load and LED1 remain on. To turn off the channel 1 output, it is necessary to move the knob (toggle switch) again to sector B, and then return it to the neutral position N. The state of the channel 2 output does not change. The output of channel 2 is turned on/off in the same way by moving the handle (toggle switch) to sector A and returning it to the neutral position N. The state of the output of channel 1 does not change. When load channel 2 output is on, LED2 is lit. In some cases, it may be necessary to adjust the N, A, and B setpoints using the remote control.

TECHNICAL SPECIFICATIONS
Dimensions (without wires): 40x17x7mm
Weight (with wires): 11 g
Number of channels (outputs): 2
Channel operating current: 10A
Power supply voltage: 3 ~ 30V
Power Connector Standard: JST