ATTENTION! Pre-order only! (term of execution 3-10 days)
Two-channel multiswitch MSWP-2HPV is designed for discrete separate switching on/off of two external loads: LEDs, lamps, relays, solenoids, low-power electric motors, etc.
A multiswitch allows you to turn on only one load out of two, or both loads will be turned off.
The MSWP-2HPV multiswitch can turn loads on and off with a current consumption of up to 10 A and a supply voltage of up to 30 V. One of the main purposes of this multiswitch is to control the operation of solenoids for opening bunkers of bait boats.

The multiswitch is controlled via a free channel of the control panel, the device itself is connected to the corresponding channel of the receiver. It is recommended to use a control panel channel with a three-position toggle switch. It is allowed to use a proportional control channel with the possibility of fixing the handle of the control panel in the neutral position.

The multiswitch circuit is powered from the receiver's power bus. The loads connected to the multiswitch outputs are powered by an external source (battery or UBEC) connected via an external power cable (see Fig. 2).

A feature of this multiswitch is the use of field-effect transistors with a P-channel as power elements for switching the plus of the power source and providing a common minus (ground) for the battery, receiver and other on-board consumers.

Load on-off point settings are fixed (see Fig. 1). In neutral position N load outputs 1 and 2 are switched off. When the control panel knob (toggle switch) is moved to sector B, load output 1 and LED1 are turned on, and load output 2 is turned off. When the handle of the control panel is moved to sector A, the load output 2 and LED2 turn on, while the load output 1 is turned off. In some cases, it may be necessary to adjust the N, A, and B setpoints from the remote control.

TECHNICAL SPECIFICATIONS
Dimensions (without wires): 40 x 17 x 7 mm
Weight (with wires): 11 g
Number of channels (outputs): 2
Channel operating current: 10 A
Power supply voltage: 3 ~ 30 V
Power Connector Standard: JST