This device is switched on via a free channel of the control panel or via the “gas” channel.
In the latter case, the device is connected parallel to the “gas” machine via a V-cable.
Adjustment of the moment of switch actuation is carried out with the help of a trimming resistor “turn-on setting”, adjustment of the actuation direction is carried out by the “reversal” jumper by moving it to another pair of connector pins. When the jumper is removed, the load output is disabled.
When the device is triggered, the “indication” LED lights up.
It is possible to connect two or more similar devices in parallel to one channel of the receiver with an individual setting of the sector and the moment of operation of each of them.
Also, this device can be used to turn on / off the travel motor with current consumption up to 20A. In this case, the motor must be shunted with a Schottky diode to prevent damage to the power MOSFET.
The device should be connected in accordance with the markings on the wires (red - plus, black - minus). A three-color wire with a chip is connected to the corresponding channel of the receiver.

Checking the performance and preliminary configuration of the device should be done before connecting the external battery and load. This is possible, since the entire signal part of the circuit, including the indication, is powered directly from the receiver.
During operation, carefully observe the polarity of connecting the device to the load and external battery. When using this device as an on-board heater, power supply is allowed only from a voltage source of 1.2 ... 1.5 V (the power minus should be connected to the engine crankcase).
Avoid getting water, dust and fuel on the device board. When mounted on board a model, care must be taken to protect the unit from vibration and shock. You should also provide air access to cool the device.
TECHNICAL DATA:
Dimensions (without wires): 45 x 15 x 8 mm
Weight (with wires): 15 g
DC current: 20 A
Short-time current: 30 A
Impulse current: 100 A
External battery voltage - 1.2...12 V
Main | |
Weight (g) | 15 |
Dimensions (LхWхH) (mm) | 45 х 15 х 8 |
Supply voltage (V) | 1,2 - 12 |
Current (A) | 20 |
Electronic RC-switch 20A (with reverse)
- Brand: Украина
- Product Code: 030020
- Availability: In Stock
-
$10.00
Order in 1 click
Related Products
Electronic remote switch DALRC 3.7-28V 20A
Designed for remote control of switching on and off various devices on your model. Such as, for exa..
$10.45
Multiswitch MSWTF-2HPV 2x10A 30V with 1 sec. fixation
Two-channel multiswitch MSWTF-2HPV is designed for discrete separate switching on/off of two externa..
$11.38
KLSW-5 Electronic OPTO-Switch with reverse 5A
The KLSW-5 electronic opto-switch is designed to turn on/off on-board devices that generate electrom..
$8.61
KLSW-8 Electronic OPTO-Switch with reverse 5A ECO (KILLSWITCH)
Electronic opto-switch KLSW-8 is designed to turn on/off on-board devices that generate electromagne..
$8.94
Tags: electronic switch, reverse
Featured
What you need to know about the propeller
How does a propeller work? A propeller converts rotation engine shaft at point blank range - the force pushing the ship forward. When the propeller ro..
Rules for charging and using LiPo batteries
A few REQUIRED rules for charging and using LiPo batteries: 1. Use only a charger designed for lithium batteries. The charger can be designed to ch..